Ferprime Black - Rust Converter

  • Quickly turns rust into a clean black layer
  • Protects the metal below the rust  preventing further corrosion
  • Safe to use
  • Suitable for use both indoors and out
  • Highly effective

In stock

Free Delivery

Telephone Orders Taken

FerPrime Black turns rust into a black corrosion resistant coating 

FerPrime Black from FUZE Products transforms unsightly rust into a rust free black surface.

With one simple application it will convert rust into a resin like film and stop further rust and corrosion from forming.

Surfaces treated with Ferprime Black  do not have to be repainted (although you can if you want)

FerPrime Black is applied directly to  rust which then  reacts to form a black, resinous layer that can resist further corrosion, protecting the underlying surface. If applied to a non rusty iron surface it will still react to form a black resin like  film which resists corrosion.

It is designed to be brushed onto the surface. It will give a coating thickness of around 20 to 30 microns.

FerPrime Black is a water based product and drying times will vary according to ambient temperature and humidity. Normally surfaces are touch dry  within  10 to 30 minutes.

Note that FerPrime Black is a reactive primer and time must be allowed for the product to react and form the black resinous layer.

If the FerPrime Black is not to be painted over, it is advisable to recoat with Ferprime after the initial coating has touch dried. This will give a final coating thickness of around 60 microns, which should be adequate for most conditions.

FerPrime Black can be thinned down with water if required, to enable its use in spray equipment. The amount of water that should be added will depend on the type of spray equipment being used.

Ferprime Black can be overcoated with a wide range of paint types using a brush, roller or spray.


How to use FerPrime Black

  • Remove loose rust and corrosion by brushing with a wire brush
  • Apply  FerPrime Black by paint brush. 1 litre should cover approximately 8 metres squared depending upon the surface being treated
  • Allow to air dry - this normally takes 10 to 30 minutes  depending upon ambient conditions.

Coating thickness  should be  20-30 microns

Please Note: To avoid the product drying out please ensure that you replace the lid after use and store in a cool area. It may require stirring prior to use

Further Information

Write Your Own Review
You're reviewing:Ferprime Black - Rust Converter

Unit 2, Zone 2, Ring Road Burntwood Business Park, Burntwood, Staffordshire, WS7 3JQ

  • Mastercard
  • PayPal
  • Visa